Titanium Metal Sheeting: Hard Stainless

This is a very easy treatment. Here is a basic recipe:

100 Titanium
2 Lime to increase strength and lower corrosion
1 Coal to increase strength further, will also unfortunately increase corrosion back
2 Cactus Sap to peak strength to Hard, will also lower corrosion
1 Gravel to lower corrosion, will lower strength a little
2 Potash to push corrosion down to Stainless, will hardly affect strength

First add 100 Titanium to the bath. Then run 10s each for the ingredients above, like this:

Different Chemical Baths behave slightly different, but the basic idea above still applies. Here is how to modify the recipe:

If, after applying the Cactus Sap, strength is not almost fully "Hard", it might drop too low when applying Gravel later. Increase Cactus Sap to 30s in that case.
If 20s of Potash treatment is not enough to get "Stainless", add another 10s of Potash.
It is possible to replace 1 unit/10 seconds of Potash with 1 unit/10 seconds of Arsenic directly after the Gravel.
It is possible to skip Lime and instead increase the time using Coal or Cactus Sap to get the
It might be possible to run first a lot of Cactus Sap, or Coal and then Cactus Sap, to peak strength and then a lot of Potash to push down corrosion, but Potash is expensive, and this has not been tested yet.

Sheetings take 2 units of treated metal and take 2 minutes to cool in a Forge upgraded with a pair of Pinch Rollers

Navigation menu