The Wiki for Tale 7 is in read-only mode and is available for archival and reference purposes only. Please visit the current Tale 11 Wiki in the meantime.

If you have any issues with this Wiki, please post in #wiki-editing on Discord or contact Brad in-game.

Charcoal Brazier

From ATITD7
Jump to navigationJump to search
English Deutsch français magyar Türkçe


Charcoal Brazier small.jpg
Size 29x11
Where Compound




Basic Info

It is a more efficient version of the Charcoal Oven, which itself is a more efficient version of a Charcoal Hearth. It can process three times as much charcoal as an oven, and six times as much charcoal as a hearth but, at half the speed. This makes the Brazier 50% more efficient than the Oven and 250% more efficient than the Hearth.

A Charcoal Brazier has no regulator.

Source

Requires Automatic Charcoal Production to use (available at University of Architecture).

Cost

Treated Metal Recipe for the sheeting

Please notice that recipes are specific to each chemical bath, so you will have to make adjustments to the recipe. Try adding a little less and see if that gets the desired result, or add a little more if needed. This is a very hard treatment, so dont try it unless you know what you are doing.

  • 38 Salts of Tungsten
  • 20 Cactus Sap
  • 8 Salt
  • 30 Coal
  • 30 Arsenic
  • 39 Salts of Titanium
  • 7 Saltpeter
  • 40 Lime
  • 50 Cactus Sap
  • 10 Gravel
  • 10 Potash
  • Permanent Focus 7 needed

The above recipe was not very good for me. Corrosion and Conductivity values were still too high when using this and purity was too low to allow very much more treatment. Jay's Metal Treatment recipes page had one that worked just fine for me. DonQuiHotep

  • 40 Salts of Tungsten
  • 40 Salts of Titanium
  • 8 Saltpeter
  • 1 Sulfur
  • 40 Lime
  • 8 Coal
  • 8 Cactus Sap
  • 5 Lime
  • 8 Cactus Sap
  • 8 Gravel
  • 8 Arsenic
  • 8 Salt
  • 35 Coal
  • 8 Cactus Sap
  • 1 Coal
  • 35 Arsenic
  • 8 Cactus Sap
  • 1 Arsenic
  • 20 Salts of Titanium

Usage

The Charcoal Brazier is used in the same way as the Charcoal Oven, it has the same interface. Start cost is 609 wood, and the return is 600 Charcoal. Requires Automatic Charcoal Production.

Related Pages

Required By